About Orkideh FAQ Contact Us

Orkideh

Cyclised rubber top coat

Color: Aluminum, other color on request
Finish: Gloss, Semi-gloss
Product description: It is used for galvanized and aluminum surfaces

Technical data:
Description: Cyclised rubber based, very fast drying, excellent water alkali and acid resistance,
resist temperature up to 300°C
Area of application: Marine and construction paints, anti-fouling, Road marking paints and paints for
swimming pool. Heat resistance aluminum paints
Physical constants:  
Color: Aluminum, other color on request
Finish: Gloss, semi-gloss
Viscosity: V15-24s DIN cup 4/25 °C
Specific gravity: 1.01-1.05 gr/100cc
Solid: 48-55
Covering capacity: 20-25 M2/Lit
Drying time: Touch dry at room temperature 5 min
Shelf time: 12 months in cool and dry place
Application details:  
Method of application: conventional spray or brush
Thinning: Thinner TC-9918
Air Spray: Spray Nozzle orifice:1.2-2 mm
Nozzle pressure:3-5 Bar
Film thickness: Dry 15-20 microns
Wet 25-30 microns
Surface Preparation: Surface should be dry & free from dust

Zinc rich cyclized rubber

Color: Gray
Finish: Flat, Matt
Product description: This primer is two component and it is clouding zinc pigment and it has good resistance in high temperature up to 300 °C.also it has been air drying and it had been hard in environment temperature at really short time

Technical data:
Description: It is two pack cyclized rubber primer, very fast drying, excellent chemical and
water resistance, excellent rust inhibitive shop primer in corrosive environments,
and resist temperature up to 300°C
Area of application: Metal, cement, etc.
Physical constants:  
Color: Gray
Finish: Flat, Matt
Viscosity: 30-35 sec D/N cup 4/25 °C
Specific gravity: A: 1.01-1.05 gr/100cc
B: 7.1± 0.1 gr/100cc
Solid: 88±2
Covering capacity: 12-14 M2/Lit
Drying time: Touch dry at room temperature 5 min
Shelf time: 6 months in cool and dry place
Application details:  
Mixing ratio: component A refer to can label/ component B refer to can label Method of
application: conventional spray or brush
Thinning: Thinner TC-9918
Air Spray: Spray Nozzle orifice 1.2-2 mm
Nozzle pressure 3-5 Bar
Airless Spray: Nozzle orifice 0.38-0.53 mm
Nozzle pressure 120-150 Bar
Film thickness: Dry 40-50 microns
Wet 50-70 microns
Surface Preparation: Surface should be dry & free from dust